Cardin S449 QZ/4 Remote control

S 449 QZ/4

New product

Brand : Cardin

Frequency : 433.92 MHz

Number of Buttons : 4

Battery : CR2032

Coding : Rolling code

More details

In stock !

16,90 € VAT incl.

More info

Take advantage of discounts on this product :

- 3% reduction with the purchase of 2 remote controls
- 5% discount with the purchase of 3 or more remote controls
- 7% discount with the purchase of 5 or more remote controls
- 10% discount with the purchase of 10 or more remote controls


Rolling code remote control, 433.92 MHz, 4 channels.
Compatible only with S449 receiver.
Warning: The remote control can be programmed without problem unless you are living in a condominium, in which case the receiver may be locked. Check before purchasing this remote.


Guide to programming your remote from an already programmed remote:

Step 1. While being near your Cardin automation, insert a small needle into the small hole of the already programmed remote control (This small hole is located below the buttons). When your receiver has made a sound, remove the needle.
Step 2. Press and hold a button on the already programmed remote control. When your receiver has emitted a sound, release the button.
Step 3. Keep pressing the button you want to program on your new remote. When your receiver has emitted two beeps, release the button.
Step 4. Repeat the procedure for each button you want to program, then wait 10 seconds. Your new remote control is now programmed!


Guide to programming your remote from your receiver:

Step 1. Open the case of your receiver. On the receiver board, keep the programming button pressed. The LED of your receiver flashes.
Step 2. Keep pressing the button you want to program on your new remote until the LED on your receiver turns off.
Step 3. Release the button on your remote as well as the programming button. The LED of your receiver flashes. Press the button on your remote again. The LED on your receiver goes out.
Step 4. Repeat the procedure for each button you want to program, then wait 10 seconds. Your new remote control is now programmed!

A note about the guide? Do not hesitate to contact us via the contact form!