Cardin S504 C4 Remote control - Domobip View larger

Cardin S504 C4 Remote control

S 504 C4

New product

Brand : Cardin

Frequency : 433.92 MHz

Number of Buttons : 4

Battery : CR2032

Coding : Rolling code

More details

In stock !

19,50 € VAT incl.

More info

Take advantage of discounts on this product :

- 3% reduction with the purchase of 2 remote controls
- 5% discount with the purchase of 3 or more remote controls
- 7% discount with the purchase of 5 or more remote controls
- 10% discount with the purchase of 10 or more remote controls


Digital remote control with dynamic codes, 433.92 MHz, 4 channels.
Compatible only with RSQ504C2 and RQM504C2 receivers.
Warning: The remote control can be programmed without problem unless you are living in a condominium, in which case the receiver may be locked. Check before purchasing this remote.


Guide to programming your remote from an already programmed remote:

Step 1. Being near your receiver, on the back, remove the upper part of your two remote controls (the one to be programmed and the one already programmed, the chrome part where it is written "OPEN" above) using a screwdriver. Place the transmitters side by side.
Step 2. Push a small needle through the "MR" button on one remote and then the other or simultaneously. The orange LED of both transmitters flash slowly.
Step 3. On the already programmed remote, press a button that is already in use on your receiver. The LED of your new remote control remains on for 3 seconds to confirm the memorization. Your new remote control is now programmed!


Guide to programming your remote from your receiver:

Step 1. Open the case of your receiver. On the receiver board, press and hold the programming button. The LED on your receiver flashes slowly.
Step 2. Press the button you want to program on your new remote. The LED on your receiver will light up quickly. Press this button again. The diode of your receiver stays on steady, then goes out after a few moments.
Step 3. Repeat for each button you want to program, then wait 10 seconds. Your new remote control is now programmed!

A note about the guide? Do not hesitate to contact us via the contact form!