Cardin S504 C2 Remote control

Take advantage of discounts on this product:

- 5% discount for 2 or more remotes
- 8% discount for 5 or more remotes
Offer available for orders of 10 or more remotes on quotation (use the contact section!).

Dynamic rolling code gate remote control TXQ504C2, 433.92 MHz, 2 channels.
The Cardin S 504 C2 gate remote control is supplied without instructions. However, Domobip provides programming guides below. The battery is included.

Compatibility of the Cardin S504 C2 remote control

This transmitter is not a universal remote control. It is only compatible with S504 receivers. Make sure this is the model you need to control your swing gate / sliding gate / door automation before ordering.

Guide to programming your remote control from your receiver :

Step 1. On the receiver card, hold down the programming button. The LED on your receiver will flash slowly.
Step 2. Press the button you wish to program on your new remote control. The LED on your receiver will light up quickly. Press the button again. The LED on your receiver lights up steadily, then goes out after a few moments.
Step 3. Repeat the operation for each button you wish to program, then wait 10 seconds. Your new remote control is now programmed!

Any comments about the guide? Don't hesitate to contact us using the contact form!

Is it possible to programme the remote control if I'm a tenant?

If you live in a condominium, you may not be able to programme the remote control yourself for security reasons. We recommend that you contact your property manager for more information before you buy.