Beninca TO.GO 2 VA Remote control

New product

Brand : Beninca

Frequency : 433.92 MHz

Number of buttons : 2

Coding : Rolling code, ARC

More details

16,10 € VAT incl.

  • No

More info

Take advantage of discounts on this product :

- 6% discount for 2 or more remotes
12% discount for 3 or more remotes

- 14% discount for 5 or more remotes
Offer available for orders of 10 or more remotes on quotation (use the contact section!).

Beninca 2-channel wireless remote control, 433.92 MHz, black with green buttons. Used to control your Beninca motorisation for garage doors and gates.

TO.GO VA transmitters are beep transmitters that can operate using Rolling Code or Advanced Rolling Code (ARC). They are supplied with a QR code on the back of the packaging for access to dematerialised instructions. The battery is included.

Equip your property with a Beninca SMART wall box suitable for TO.GO remote controls! Once your beep has been programmed, place it in the wall-mounted case, the design of which will adapt very easily to the wall of your home. Your Beninca TO.GO remote control will no longer go astray and will become an elegant, easy-to-use switch!

Buy your TO.GO remote control with a black bracket with clip for your car's sun visor! It's quick and easy to install, and doesn't require any additional fixing accessories.
It is also possible to turn the clip into a wall bracket, but this will require two Molly plastic plugs and two fixing screws, which are not included!

Compatibility of the Beninca TO.GO VA remote control

Please note that this remote control is not universal. It is only compatible with TO.GO VA transmitters and its previous model, the TO.GO WV. It is also compatible with any TO.GO remote control model as long as the installation uses ARC coding.

Guide to programming your Benincà TOGO 2VA remote control :

Step 1: Determine the operating mode of your installation (rolling code or ARC). Hold down the two buttons on the new remote control. If the LED flashes three times in succession with a pause before lighting up steadily, the left button will operate in ARC (Advanced Rolling Code) mode and the right button in standard rolling code. If the LED flashes four times, all the buttons will operate in standard rolling code. If the LED flashes twice, all the buttons will operate in ARC mode. Repeat this operation until you obtain the number of flashes corresponding to the desired operating mode.
Note that when you receive your new remote control, all the buttons are normally configured to operate in ARC mode.
Step 2: Press the programming button on the receiver board. The LED will light up or flash.
Step 3: Within 5 seconds, take your TO.GO remote control and press the button to be programmed. Depending on the receiver, it will indicate via the LED or display that the button has been memorised.

Is it possible to programme the remote control if I'm a tenant?

If you live in a condominium, you may not be able to programme the remote control yourself for security reasons. We recommend that you contact your property manager for more information before you buy.