Sommer Telecody+ Remote control

Rolling code gate/garage door remote control, 868.95 / 868.8 MHz, 12 channels.

This is a hand-held transmitter that can also be used as a wireless keypad. Depending on the environment, it can be used up to 50 metres away.
Telecody+ has an IP64 protection rating, making it extremely resistant to dust and the elements.
The Sommer Telecody+ remote control is supplied with full installation and operating instructions, fixing accessories and the battery is included.

Sommer Telecody+ remote control compatibility

This transmitter uses the SOMloq2 system and is backwards compatible with the Somloq Rolling-Code system to control your swing gate / sliding gate / door operator.
As a result, this remote control is compatible with all Sommer receivers operating in 868 MHz.

However, the Telecody+ is not a universal remote control, i.e. it is not compatible with receivers from other brands.

Please note: The Telecody+ remote control is compatible provided that the compatible functional reference ends with -00001.
This information is given on the back of your transmitter. Pay particular attention if you live in Belgium, Germany or the Netherlands.

Guide to programming your Telecody+ :

Step 1. When you receive the Telecody+ transmitter you have ordered, you will find a sticker with a reset code on the buttons. Peel off this sticker, but keep it in a safe place, because without it, you won't be able to reset your transmitter in the event of mishandling or forgetting the code.
Step 2. Press and hold the M button on the Telecody+ for 10 seconds. The LED on the remote control will flash and the backlit buttons will light up. On the receiver board, press the programming button. The LED on the receiver flashes or lights up steadily.
Step 3. On the Telecody+, press the first digit of your future code. At this point, simply pressing this digit will activate the opening and closing of your door.
Step 4. Press the P button on the Telecody+, then press the first digit of your future code. Press P again, then type in the code you want to set. Press P a third time.

Do you have any comments about the guide? Don't hesitate to contact us using the contact form!

Is it possible to programme the remote control if I'm a tenant?

If you live in a condominium, you may not be able to programme the remote control yourself for security reasons. We recommend that you contact your property manager for more information before you buy.