FAAC 391 Articulated arm operators

New product

Brand : FAAC

Maximum leaf weight : see chart

Maximum leaf width : 2 m (2.5 m with electric lock)

Max speed : 13 degrees / second

Operator dimensions : 184 x 256 x 311 mm

Electronic board : E024S integrated (on the master operator)

Power supply : 220-240 V

More details

205,40 € VAT incl.

  • Complete kit
  • Master operator
  • Slave operator

More info

The FAAC 391 electromechanical articulated arm operators are 24V operators that allow you to automate the opening and closing (partial or total) of the leaf(s) of your swing gate. The maximum weight of a leaf to be controlled by the motorisation depends on its width. We invite you to check from the graph below:

Each operator is placed on the side of a leaf to allow the opening of your gate, among which :
- The "master" operator 391 E contains an integrated E024S electronic equipment and a transformer.
- The "slave" operator 391 does not contain any electronic equipment.

Both operators are equipped with an articulated arm and an unlocking key.

Thus, if you have a single-leaf gate, only the master operator is required. If you have a double-leaf gate, you need a master operator and a slave operator (which will be controlled by the master).

ATTENTION: For the operators to work properly, the distance between the gate hinge and any side walls and fences must be greater than 0.725 m!

The E024S electronic board has a number of operating logics and programmable functions. It will also allow your motorisation to work with FAAC's own Bus 2 easy technology. It is also possible to connect an XF 868 frequency module to control your swing gate remotely with FAAC XT2 868 SLH LR or XT4 868 SLH LR remote controls.

For more information, we invite you to download the FAAC brochure available in the documents attached below.


Choose the FAAC 391 operator alone or in a complete kit

The complete kit includes, in addition to the two 391 operators :

- 2 XT4 868 SLH remote controls to enable you to control your swing gate remotely

- 1 XF 868 frequency module to be connected to the E024S electronic board to allow the use of the remote controls

- 1 FAAC XLED warning light to signal the vicinity of the opening or closing of your swing gate, allowing safe entry or exit

- 1 pair of XP 20 BD photocells operating with Bus 2 easy technology and compatible with the E024S electronics integrated in the master operator. These cells will stop the gate if an obstacle (child, animal or any other person or object) is detected.